| Q |
What do I
do when the wrapped roll of coins does not look neat and
nice? |
| A |
Open the
front door and eliminate any paper scraps stuck inside
the hook of wrapping part. |
| Q |
What do I
do when the coin lies on top of another coin during the
process of coin ejection? |
| A |
Adjust the
ejector belt and lower its height properly. |
| Q |
What do I
do when the piling-up coins get torn off during the course
of transfer for wrapping? |
| A |
Adjust the
downside bolt of the “carrying part” so that
it is enable to pick up its center point of the piling-up
coins. |
| Q |
What do I
do when a coin is stuck inside the machine? |
| A |
Make sure
to do a removal of coin surely after the power is turned
off. |
| Q |
What do I
do when the electric power does not come in despite of
turning on the power switch? |
| A |
1. Check
whether the electric detachable power cord is properly
connected to the wall outlet.
2. Check the fuse. |
| Q |
What do I
do when the machine suddenly does not operate? |
| A |
1. Turn on
the power switch again and press power switch button ON
and OFF
Repeatedly.
2. Turn on the power switch and press “Clear”
button repeatedly. |
| Q |
In case the
coins on the centrifugal disc are being overfed from the
hopper. |
| A |
After removing
all the coins from the centrifugal disc, adjust a height
of level sensor affixed on the middle part of coin ring
covering the centrifugal disc. (Desirable height of level
sensor is around 5 mm or so) |
| Q |
What do I
do when the gear of wrapping parts do not work properly? |
| A |
Check whether
there are any paper scraps and any items inside the gear.
If yes, please remove it. |
| Q |
What do I
do when the handle (knob) of supplying parts (plastic
tube accommodating 50 coins for wrapping) does not turn
well? |
| A |
Check whether
there are any bent and damaged coins and other items around
the plastic tube. If so, please remove it. |
| Q |
What do I
do when the film has not been cut properly with the edge
of knife? |
| A |
Open the
belt covers at the upper side of wrapping parts and fasten
the belt more tightly. |
